ELASTIC STRESS AND SAFETY ASSESSMENT OF AN OPEN-ENDED THICK-WALLED TUBE: ANALYTICAL AND FINITE ELEMENT COMPARISON


Bektaş İ. H.

16th International Azerbaijan Congress on Life, Engineering, Mathematical, and Applied Sciences, Baku, Azerbaycan, 20 - 22 Eylül 2026, ss.124-149, (Tam Metin Bildiri)

  • Yayın Türü: Bildiri / Tam Metin Bildiri
  • Doi Numarası: 10.30546/19023.978-9952-610-91-5.2026.100.1148
  • Basıldığı Şehir: Baku
  • Basıldığı Ülke: Azerbaycan
  • Sayfa Sayıları: ss.124-149
  • İstanbul Gelişim Üniversitesi Adresli: Evet

Özet

This study presents an analytical–numerical comparison and elastic safety assessment of an open-ended thick-walled S355 steel tube subjected to uniform internal pressure. The tube had inner and outer diameters of 80 and 120 mm, respectively, and was analysed at internal pressures ranging from 20 to 100 MPa. Because no pressure-loaded end cap was present, the pressure-induced axial membrane stress was taken as zero. Lamé’s elasticity solution was used to determine the radial, hoop, and von Mises stress distributions across the wall. A two-dimensional plane-stress finite element model consisting of 6,240 CPS4R elements was developed in Abaqus/Standard, and the resulting stress distributions were quantitatively compared with Lamé’s analytical solution. The radial stress was compressive throughout the wall and increased nonlinearly from the applied pressure at the bore to zero at the traction-free outer surface. The hoop and von Mises stresses attained their maximum values at the bore and decreased towards the outer surface, identifying the inner surface as the critical location for yielding. The maximum deviation between the analytical and finite element results was 1.80% for non-zero radial stresses, 1.97% for hoop stresses and 2.85% for von Mises stresses. The von Mises stress difference at the critical inner surface was lower than 0.89%. The maximum von Mises stresses for an internal pressure of 100 MPa were 321.87 MPa and 319.48 MPa for the analytical and numerical solutions, respectively, and both are lower than the nominal S355 yield strength of 355 MPa. First yielding was estimated at the bore using the linear-elastic solution. It occurred at approximately 110.3 MPa internal pressure. The close agreement between analytical and finite element stress distributions indicates that the numerical model reproduced the expected elastic stress response over the pressure range investigated.